Installation Guide 1n
English
Installation
At the recommended height of 2.1m (7ft) to 2.7m
(9ft) ± 10%, Digigard DG85 provides full
coverage from 1.5m (5ft) to 11m (35ft) as shown
in Figure 5 on page 29. The Digigard DG85
includes a weatherproof casing so it can be
installed outside.
Avoid placing the detector within proximity of the
following sources of interference such as direct
sunlight, reflective surfaces and moving cars.
Do not touch the sensor surface as this
could result in a detector malfunction. If
necessary, clean the sensor surface using
a soft cloth with pure alcohol.
After selecting the detector's location, drill or
punch out holes for the screws (Figure 4 on page
28).
The DG85 can also be mounted using the
Paradox Swivel Mount Bracket (469). The
swivel mount may allow for easier mounting.
If using the swivel mount, it is recommended
that you seal the space where the swivel
mount is connected to the back cover with
some silicon or with a rubber gasket to
ensure that moisture does not enter the
detector.
DG85_TI04.fm Page 1 Tuesday, February 15, 2005 9:17 AM
To Next Page
Loading...
Need help?
General
