Paradox HD88

HD88
720P HD Outdoor Camera
Installation Manual
**Compatible with Insite
GOLD and SWAN Server**
Introduction
The HD88 is an IPX4 outdoor 720P HD camera with built-in
audio, pet immune security motion detector, with Ethernet and
Wi-Fi. It provides up to 30 minutes of internal recording and
comes with a removable rain hood. The BR88 wall bracket is
an optional accessory.
Installing the HD88
If you are installing the HD88 near any reflecting surface, please
note that it may affect the quality of the night vision due to the IR
reflection.
If wall bracket tamper is connected, tamper will automatically be
detected by the camera. Tamper will follow recognition settings set
in the panel.
Unscrew and
remove cover
Lock and Tamper
Drill Out
Holes
Mount back on wall
or bracket
Terminal
Block
Anti-
Tamper
Power Requirements
It is recommended to use the PS25 power supply module that is
capable of powering a maximum of 5 x HD88’s.
HD88 Ethernet Wiring
Connect the HD88 camera with a CAT5e or better cable using
pairs 2 & 3 (pins 1,2,3,6). The maximum cable length is 50 meters.
HD88 Bus Wiring
Connect the PIR with a 4-core 14/0.20 cable or better.
BR88 Wall Bracket Installation
- 1 -

Paradox HD88 Specifications

General

Signal System	PAL/NTSC
Lens Mount	M12
Storage	MicroSD card (up to 128GB)
Day & Night	Yes
Video Frame Rate	25fps

Summary

Power Requirements

HD88 Ethernet Wiring

Connect the HD88 camera with a CAT5e or better cable using pairs 2 & 3.

HD88 Bus Wiring

Connect the PIR with a 4-core 14/0.20 cable or better.

Introduction

Installing the HD88

BR88 Wall Bracket Installation

Instructions for installing the optional BR88 wall bracket.

Creep Zone Pet Selection

Installation Height

Guidance on optimal installation height for pet immunity.

HD88 Camera Set Up and Configuration

Launch the Insite Gold app

Step 1: Launch the Insite Gold application on your device.

Select New Installation

Step 2: Choose 'New Installation' and then the 'Create' button.

Type in Panel Details

Step 3: Enter Panel Serial Number, Site ID, and Client's Email Address.

Add WiFi Camera Configuration

Step 4: Press 'Add WiFi Camera' if configuring a WiFi camera.

Select WiFi Network

Step 5: Choose the WiFi network for camera registration.

Enter WiFi Password

Step 6: Input the WiFi password and press continue.

Present QR Code to Camera

Step 7: Present the generated QR code to the camera lens.

Configure WiFi Camera

Step 8: Press 'Configure' to modify settings for the WiFi camera.

Save Settings

Step 9: Configure settings and press Save.

Create New Site and Activate

Steps 10-11: Create the site, receive an email, and click 'Activate'.

View Site in App

Step 12: The created site will be displayed in the application.

PIR Detector Beam Patterns

Top View

Diagram illustrating PIR detection zones from a top-down perspective.

Side View

Diagram showing PIR detection range based on installation height.

Technical Specifications