Printed in Canada | 09/2011
TM40 Quick Install Guide
TM40 Touch Interface
Module
Quick Install Guide
Installation
1. Using a screwdriver, pry the front housing assembly from
the back plate.
2. Mount the back plate to the wall by securing a M3.5 or #6
screw in each of the dedicated mounting holes and tamper
hole. Ensure that the UP arrow on the back plate is in the up
position.
3. Assemble both items by joining the hooks on the back plate
to their respective slots on the front housing assembly.
NOTE: Make sure to connect the unit’s 5-pin connector before
proceeding to the next step.
To Next Page
Need help?
General
