40 Cone-Fire / Ramp-Hold Do not leave your kiln unattended during operation.
Sentry Cone-Fire Shorthand Programming
After you press the key(s) in the left column, the message to the right will appear. Press 1 from [IDLE]. If the 1 key does not
respond, your controller does not have Cone-Fire. (See also page 11.)
KEYS TO PRESS DISPLAY COMMENTS
Apply power to kiln IDLE Press Enter if IDLE doesn’t appear.
1 CONE Enter the cone number.
Cone # (i.e. 05) 05
ENTER SPD Enter the firing speed.
1(Fast), 2 (Med.), or 3 (Slow) FAST The firing speed appears.
ENTER PRHT Enter Pre-heat time.
Pre-Heat time (0 if none) 00.00 Pre-heat time appears.
ENTER HOLD Enter hold time.
Hold time (0 if none) 00.00 Hold time appears.
ENTER COOL Enter slow cooling rate.*
Slow cooling rate (0 if none) 0000 Shows degrees per hour.
ENTER IDLE Kiln is ready to fire.
ENTER -ON- Kiln is now firing. Press 6 for
Program Review.
The kiln is now firing to the cone you selected.
*The COOL prompt appears only after you have turned on the Slow Cooling option. See page 21.
Appendix G:
To Previous Page
Loading...