Paralinx Arrow MX888R - Page 12

12
5. Press the “OK” button on Remote to enter Setup Menu.
Select "Add New Video Source."
Setup
■ Add New Video Source
6. WithinaminutetheregistrationprocesswillstartonboththeTransmitter
andReceiver.Thefollowingmessagewillappear:
Please Activate Registration on Transmitter Unit
7. Press the registration button on your transmitter for 3 seconds and release.
*Note:Oncethesyncingprocessstartedonthereceiver,thereisoneminutetoinitiateregistrationonthetrans-
mitter side. If the syncing process on the transmitter was not started on time, the syncing process will have to
be restarted from stage 5.
8. Pressthe"OK"buttononremotecontroltoregistertheTransmitter:
 8.B Waitfortheprogressbartocompleteandyournewreceivershouldbe
successfully synced to the desired transmitter.