Paralinx Arrow MX888R - Receiver

8
RECEIVER
1. 5V DC power input port — DO NOT FEED OVER 5V!
2. IR Sensor Port — used for connecting IR sensor to add additional receiver
units to a network
3. MiniUSBport—usedforpossiblefuturermwareupgradesandrepairs
4. “PICTURE” LED indicates when receiver unit is receiving a supported signal
5. "SYNC”LEDindicatesstatusofthetransmitter/receiverconnection.Ifashing,
receiver has lost or is searching for a connection to receiver units
6. HDMI port — video output
7. ¼ 20’’ Screw hole — CAUTION! Attempting to over-tighten into this may
crack casing and damage receiver unit.