PARAMOUNT BED CA-54380 - Operation Procedures: Leg Section Base Adjustment; Leg Section Base Angle Adjustment

25
6. Adjusting the angle of the leg section base
■
The angle of the leg section base can be manually adjusted in two levels.
●
Normally, the leg section base comes to the position (b) when the knee section base is raised.
●Adjustment to the position (a) should be performed when the knee section base is raised.
●When adjusting to the position (a), hold the end of the leg section base and pull it up, lift the
end of the stay up. When the end of the stay comes to the position (A), lower the leg section
base slowly.
●When adjusting to the position (b), hold the end of the leg section base and pull it up. When
the end of the stay comes to the position (B), lower the leg section base slowly.
●
The angle of the leg section base must be adjusted by at
least two persons from both sides of the bed. If only one
person attempts to adjust the angle, the person may get
caught between the leg section base and main frame,
resulting in injury.
Knee section base
Leg section base
Stay
Main Frame
(A) (B)
(a)
(b)
OPERATION PROCEDURES
6