Park Tool PCS-9.2 User Manual

5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
PARK TOOL CO.
PCS-9.2 Home Mechanic Repair Stand
Assembly and Set Up
1. Line the Hard Stop (#27) up with the two holes in the Large Vertical
Upright (#7) such that the arrow on the Hard Stop (#27) is pointing
upward. Using a 3mm hex wrench, insert the M5 x 12mm Screws (#17)
into the holes in the Hard Stop (#27) and screw them into the Large
Vertical Upright (#7). Tighten to 3.5Nm max (Do Not Overtighten)
2. Slide the Yoke (#3) down the Large Vertical Upright (#7) until it bottoms
out on the Hard Stop (#27). Insert the M6 Flange Nut (#19) into the hex
pocket in the Yoke (#3). From the other side of the Yoke (#3) insert the
Knob (#18) into the hole in the Yoke (#3). Screw in the Knob (#18) until it
is fully tightened. Fully tightened is when both flanges on the Yoke (#3)
come into contact with each other.
3. Assemble and install the hardware and mating pieces in the order shown
through each Leg (#2) and Leg Strap (#10). Using a 5mm hex wrench and
a 13mm box end wrench, tighten the M8 x 60mm Screw (#14) to 5 Nm.
4. Disassemble the Cone, three Washers (#22) and Clamp Handle as
shown. Install the Clamp Assembly (#21) and its components into the Top
Tube Assembly (#20) as shown.
5. Remove the Collar (#8) from the Top Tube Assembly (#20). Install the
large end of the Collar (#8) onto the Large Vertical Upright (#7); push the
Collar (#8) down until it stops. Insert the M5 Flange Nut (#4) into the hex
pocket in the Collar (#8) as shown. From the other side of the Collar (#8),
insert the M5 x 30mm Screw (#16) into the Collar (#8) and fully tighten
using a 3mm hex wrench. Insert the M6 Flange Nut (#19) into the hex
pocket in the Collar (#8) as shown. From the other side of the Collar (#8),
insert the Knob (#18) into the Collar (#8) and lightly tighten.
6. Slide the Top Tube Assembly (#20) into the Collar (#8) on the Large Vert-
ical Upright (#7). Set at desired height and fully tighten the Knob (#18).
Note: Always remove the bike when making adjustments to the working
height. Do not set height beyond “max” height line on extension tube.
65
18
8
7
16
4
19
3
1
1
2
11
13
13
10
14
1
17
17
27
7
2
19
27
18
3
7
4
22
20
23
21
24
PCS-9.2 Instructions / Instructions / Anleitung / Instrucciones

Park Tool PCS-9.2 Specifications

General

Weight Capacity	up to 80 lbs (36 kg)
Height Adjustment	Yes
Type	Repair Stand
Base Diameter	24 inches (61 cm)
Clamp Jaw Opening	23–76 mm (1" to 3")
Height Range	39 to 57 inches (99 to 145 cm)
Folded Height	36" (91 cm)
Material	Steel and Aluminum
Color	Blue