Parker Hydraulics GRESEN V10 - Assembly Studs

Model V10 Service Bulletin HY14-2701-M1/US - TORO Specific
Revision: 01-01-2005
4
Assembly Studs
Torque to Maximum 13 - 15 Ft Lbs (17 - 20 Nm) For Dry Tie Bolts
Torque to Maximum 10 - 13 Ft Lbs (13 - 17 Nm) For Oiled Tie Bolts
2
3
1
CAUTION
If the stud nuts are not tightened to the proper torque, valve spools may bind or stick, or cause O-Ring
seals to extrude.
Figure 1. Assembly Studs
Ref No. Description Quantity
1
2
3
4
Single Section Stud
Two Section Stud
Section Seal Kit (See Page 5)
Nut
Bracket (Short) for manual valves
A/R
8
2
2
2
4