Parker 2014 - Switch Panel Functions; Bilge Pump

www.parkerboats.net
40
gauges and switches
SWITCH PANEL
At the helm station you will nd an accessory switch panel. These accessory switches are specied below.
BILGE PUMP
This switch serves as an overriding manual switch in the event of failure of the automatic switch in the bilge.
COCKPIT LIGHTS
The cockpit lights provide illumination for the cockpit area.
HORN
The horn is sounded by pressing the momentary switch on the panel or on console. It should be used to warn or alert other boats or persons.
LIVEWELL
This switch activates the livewell pump. On models that have the water pickup mounted on the bottom of the boat, ensure that the valve under the
pump is in the open position. Most models also have a ow control on the aerator tting in the livewell–use this to adjust ll and circulation rates.
WASHDOWN
This switch pressurizes the wash down system.
NAVIGATION / ANCHOR LIGHTS
Your boat is equipped with lights that meet international lighting regulations. The three position switch (NAV-OFF-ANCHOR) changes the lighting
conguration to running or anchor lights. Select the NAV position when running at night (running lights). The NAV position will illuminate the red/
green combination light forward and the white all around light. Select the ANCH position while anchored at night. The ANCH position will illuminate
only the white all around light. Be sure to stow the bimini top at night if it obstructs other boats ability to see the all around light.
ACCESSORY
Switches, fuses and breakers labeled “ACC” are unused. These components are provided for the addition of non-factory installed accessories.
CIRCUIT BREAKERS
Circuit breakers are located either on the switch panel or nearby on a dedicated breaker panel. If a breaker trips repeatedly, troubleshoot the circuit
for shorts or a malfunctioning device. Wiring diagrams for several current Parker models are included in this manual. Contact the Parker factory if your
wiring diagram is not included.