Bulletin 4391-B400S
EXACTOL
®
400 Series Tube Benders
2
Parker Hannifin Corporation
Tube Fittings Division
Columbus, OH
www.parker.com/tfd
Parts and Accessories
Bender Parts and Accessories
Carrying Case
550572 (412 only)
Seal-Lok Close
Bend Adapter
Bench Mounting
Adapter
Handle
Slide Blocks
Typical Radius Blocks
Three Hole
Two Hole
Close Bend
EXACTOL Bender
Bender Construction
Each bender consists of a cast aluminum frame and
base, with a manual crank-operated steel worm gear
mechanism. A 60:1 ratio enables the operator to make
bends up to 180° in one continuous smooth operation
without strain or fatigue. Center drive shaft and worm
gear shaft are supported with pre-lubricated ball bear-
ings. The worm gear has a ball-type thrust bearing, and
is completely enclosed for safety and protection from
external damage. The main base of the benders has a
square base for clamping in a vise or each bender can
also be mounted in an adapter unit and fastened to a
workbench.
Slide Block
Inch Sizes Part #
4, 5, 6, 8,10, 12
550585
14,16,18, 20
621045
24
870150
Metric Sizes Part #
6, 8, 10, 12, 14mm
820091
15, 16, 18, 20mm
820092
22, 25, 28, 30mm
820093
38mm
870150
EXACTOL Bender
(with Handle and Tie Bar)
Model # Tie Bar Part #
412 N/A
560569
424 Included
621044*
Bench Mounting Adapter
Model # Part #
412
550570
424
631156
*Previously Model #420. Part number
621044 has been upgraded in capacity
to support bending of 1 1/2” tubing.
Seal-Lok Close Bend Adapter
Tube
O.D.
(in.)
Threaded
Pin Part No.
Seal-Lok
Adapter Part
No.
1/2
930420-8 930421-8
5/8
930420-10 930421-10
3/4
930420-12 930421-12
1
930420-16 930421-16
1-1/4
930420-20 930421-20
1-1/2
930420-24 930421-24
To Next Page
Loading...