10
Pump and Motor Division
Trollhättan, Sweden
Service Manual
Series F1/T1
HY30-5501-M1/UK
Assembling
2.
Place the pistons and the barrel support in
the cylinder barrel. Place the shaft over the
pistons and on the barrel support. Turn the
-
ble the cylinder barrel on the end cap. En-
3.
4.
in two steps. First step with the assemble
tool alone. Second step with assemble tool
outher diameter of the casette seal with hy-
Fasten the assembly screw a couple of
possible. Reassemble the protective wash-
Fasten the end cap in a vice with the center
shaft upwards.
1.
Pressed in two steps.
Turn the shaft
at least on rev.
to ensure correct
To Next Page
Loading...
