Parker PGMT-5200 - Assembly - Shaft Connection; Shaft Joining and Spline Alignment; Locating Pin and Knob Tightening

24 25
ASSEMBLY
Insert the locking knob into the shaft connector.
Pull and hold the locating pin while securing the
lower shaft into the joint
WARNING! Always make sure that attachments are in place correctly and tightened suiciently before use.
NOTE: This process can be repeated when attaching the hedge trimmer attachment, chainsaw attachment and also the extension pole.
NOTE: Take extra care aligning the splines within the shaft. If the splines are not connected correctly the machine will not function in the manner intended.
ASSEMBLY
5
SHAFT TO JOINT ASSEMBLY
6
ALIGN THE SPLINES
7
8
JOIN THE SHAFTS
RELEASE LOCATING PIN
9
TIGHTEN KNOB
Release the pin and rotate the lower shaft until the
joint is locked into position.
Secure the joint by tightening the knob.
To tighten the knob turn in a clockwise direction.
When inserting the shaft into the joint pay
particular attention to the splines within the shaft.
It is essential that the splines are connected
correctly for the machine to operate.
Once you are satisfied that the splines and the
locating pin hole are aligned suiciently, connect
the shaft to the joint.