28 29
INSTALLING THE 3 TOOTH BLADE
Install washer “A” as illustrated above. Align the
hole in the washer with the hole in the spool collar.
Place the three tooth blade so the centre hole sits
within washer “A”.
It is important that the blade sits correctly
within washer “A” and not in an o-centered
position which can cause excessive vibration
and premature damage to the lower shaft.
1
INSTALL LOWER WASHER
2
ATTACH THE BLADE
3
INSTALLING THE 3 TOOTH BLADE
Install washer “B” as illustrated above to secure
the blade to the shaft.
Lock the axle by placing the allen key inside the
locating hole of the collar and tighten the locking
nut using the wrench provided, turning
anti-clockwise until secured tightly.
(Follow steps 8 & 9 within "Assembly" on how to
lock the axle.)
IMPORTANT!
Place the split pin (where applicable) inside the
thread to prevent the nut coming loose.
4
SECURE UPPER WASHER
TIGHTEN LOCKING NUT
5
SECURE THE NUT
NOTE: The hub is reverse threaded so to tighten the nut you will have to turn
it in an anti-clockwise direction to ensure that it is secured in place along with
the chosen cutting attachment. To loosen the nut use the wrench provided to
turn it in a clockwise direction.
NOTE: Please be aware that Washer "A", Washer "B" and 3 Tooth Blade Nut (Locking Washers) may come pre-installed on the hub of the machine.
i
i
To Next Page
Loading...