72 73
TROUBLESHOOTING HEDGE TRIMMER ATTACHMENT
TROUBLESHOOTING CHAINSAW ATTACHMENT
PROBLEM POSSIBLE CAUSE SOLUTION
Chain does not move
or is too tight.
Insuicient chain lubrication.
Check oil level in reservoir.
Check oil lines are not blocked.
Chain moves while
engine is at idle.
Idle is set too high. Adjust the idle setting until the chain stops.
PROBLEM POSSIBLE CAUSE SOLUTION
Poor cutting
performance.
Clogged blades.
Blades blunt.
Stop engine. Clean and lubricate blade assembly.
Have the blades serviced or replaced by an authorised service centre.
Unusual noise from the
cutting head.
Insuicient grease in the
gearbox assembly.
Stop engine. Add grease to the gearbox before continuing.
To Next Page
Loading...