Parker PPLM-21196 - Engine Starting Procedure; Set Deck Height; Priming the Engine; Start;Stop Lever

To Next Page

To Previous Page

30 31

When starting a cold engine, press down the

Primer fully 3-5 times.

Put the throttle control lever in the START position

before starting

PRIMING THE ENGINE

SETTING THE THROTTLE

PRESS X 

ENGINE STARTING PROCEDURE

WARNING! Using the primer too many times may cause the engine to flood. When starting a warm engine, the primer does not need

to be used. If the engine stops due to a lack of petrol, refill and press down the primer 3-5 times.

SECURING THE STARTER ROPE

Stand behind the mower, pull the engine Start/Stop lever

toward the upper handle. Place your other hand on the

starter handle, pull the starter handle out approx.

10-15cm until you feel a resistance and then start the

Engine with a sharp pull.

Once the engine is running, put the starter rope Into the

rope guide

NOTE: If the engine fails to start after three pulls, repeat the process.

NOTE: If the engine won’t start after you have operated the starter several times, the engine may

be flooded with excess fuel.

START/STOP LEVER

ROPE

GUIDE

STARTER

ROPE

Before attempting to start the engine set the deck

height to the highest setting. This will prevent the

blade from catching on any uneven ground and

make the machine much easier to start.

SET DECK HEIGHT