32
FLOODED ENGINE PROCEEDURE
33
NOTE: Install the spark plug carefully by hand, to avoid cross-threading.
After the plug is seated tighten 1/8 to 1/4 turn with a spark plug wrench to compress the washer.
FLOODED ENGINE PROCEEDURE
DISCONNECT COIL PACK
If the engine won’t start after you have operated the starter
several times, the engine may be flooded with excess fuel.
To unflood the engine first release the engine start/stop
lever to stop engine.
Locate and disconnect the coil pack from the sparkplug.
This can be found at the front of the machine next to the
exhaust.
START/STOP LEVER
1
2
REMOVE & DRY SPARKPLUG
The sparkplug is easily accessible with the coil pack
removed.
Remove the sparkplug using the sparkplug wrench
provided. Dry the spark plug and then reinstall it. Follow
the starting proceedure again carefully
LOCATE THE SPARKPLUG
3
4
To Next Page
Loading...