44 45
SET THE GAP
TO .MM
X
Y
Z
SPARK PLUG MAINTENANCE
• Once the engine has cooled, twist o the spark plug cover/coil pack lead.
• Carefully Remove the spark plug using a spark plug wrench supplied.
• Clean the spark plug with a wire brush (not supplied) to remove any deposits.
• Using a feeler gauge set the gap to the correct mesurement of 0.75mm.
• Install the spark plug carefully by hand being careful not to cross the threads.
• After the spark plug is seated correctly, tighten with the wrench supplied
.
MAINTENANCE
MAINTENANCE
AIR FILTER MAINTENANCE
• Remove the air cleaner cover by turning it in an anti-clockwise direction(X).
• Separate the Air Filter element (Y) from the Air Filter Housing (Z).
• Clean the air filter element with warm water and mild soap.
• Allow the air filter element to dry thoroughly before re-installation
• Re-assemble the air filter assembly as shown in the illustration.
• When the air filter is fully re-assembled the machine can be used once again.
WARNING! Never run the machine without the air filter element installed as this can damage the engine beyond repair.
WARNING! Never touch the coil pack/sparkplug when the machine is running as there is a risk of electric shock.
To Next Page
Loading...