EasyManua.ls Logo

Parker TC1475 - H-PARAB emendation circuit; Color driver; Power supply

Parker TC1475
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TC1475 / TC2175 / TF2139
18
Circuit Analysis
work point. Field feedback signal enter pin7 of LA7841. VD451C451
buildup a bootstrap rise voltage circuit. The power supply for pin6 of LA7841
is 26V during scan time and bootstrap rise voltage to 48V during flyback
time. In this way, the work efficiency of field output level is improved and
also the voltage of power supply for pin7 will not less than the pulse amplitu-
de of pin5 during flyback, and eliminate retrace efficiency accordingly. By
the way, if the linearity of scan is not well, it is something wrong with boots-
trap rise voltage circuit commonly.
12.7. H-PARAB emendation circuit:
The principle of H-PARAB emendation is to using field parabolical wave to
modulating amplitude of horizontal scan current. The current accretion
according to parabolical wave rule during electron beam scan the middle of
screen and so on the H-PARAB raster turned into rectangle raster.
12.8. Color driver
Tricolor signal amplified by tricolor driver. The white balance adjustment of
this chassis completed under the control of I2C bus.
12.9. Power supply
1A3 power supply: The power supply of this chassis adopt self-excitation
pulse transformer coupling switch power. It’s very steady because of the
photo-electricity transfer component adopted for stabilized voltage sam-
pling.
1Power supply analyses
A.Rectifying
A.C. 220V is delivered to bridge rectifier circuit buildup by VD503~VD506
after filted by noise filter composed by L501R501C501C502, and
transformed to 300V D.D. voltage after filted by L502C507 and powe-
red supply for collector of V513 by elementary coil of switch mode trans-
former T511.
BOscillator circuit
Self-excitation oscillator circuit buildup by switch transistor V513 and
switch-mode transformer T511, and the error sampling circuit buildup by
R552~R554RP551VD560V533N501.
C.Stabilized voltage
Photo coupler N501 buildup by a LED and a photo trail-transistor. The
work state of photo trail-transistor controlled by the light emitted by LED.