TC1475 / TC2175 / TF2139
21
Descriptions for the operation of factory mode
Descriptions for the operation of factory mode
14.
14.1. How to enter the factory mode:
A、Use remote control：
Press panel Volume down (V-) key of the TV set to lower the volume to
0(don't release it) while pressing the display key of the remote unit to enter
debug menu of factory mode 。
B、Use factory remote control：
Press“FAC”key, goes to the debug menu of factory mode directly
2）How to exit from factory mode
A、Use remote control：
1）Press ”DISP” key, then TV system will exit from the factory debug
menu status to normal status
2）Switch off the power supply and power on, then TV system will exit
from the factory mode and goes to normal status
B、Use factory remote control：
Press FAC” key, then TV system will exit from the factory debug menu
status to the factory aging mode, Press “FAC” key again, system will go
to normal status.
14.2.Direct key function descriptions for factory mode, In factory mode,
some keys function will be changed to factory function key for
debugging.
1） Mute Key： Page Up for factory mode menu
Return Key： Page Down for factory mode menu
“CH+、CH-” Key： Select the item of menu
“VOL+、VOL-” Key： Modify the data
2) Press “-/--” Key，V Stop function will implement and shows a horizontal
line for the white balance adjustment.
“1” Key R-CUT increase
“4” Key R-CUT decrease
“2” Key G-CUT increase
“5” Key G-CUT decrease
“3” Key B-CUT increase
“6” Key B-CUT decrease
4）Press“DISP”key, 4 kind of test signal will be displayed on the screen.
To Next Page
Loading...