Parkit360 Force Owner’s Manual 12
5. Make sure the weld spots are
oriented as in the picture shown
on the right. This orientation is
important for safe use of the
unit.
6. With your trailer jack, lower the
trailer down onto the ball and
lock it as you normally would.
Again, please check that the
weld spots on the ball are
positioned correctly (as shown in
step 5).
(Unit shown in picture is equipped
with the optional Battery Box.)
7. With pressure off the dolly (using
the trailer jack), tighten the ball
mount collar (counter-clockwise)
using the supplied tightening
bar. As you tighten it, you will
see the gap between the top of
the Ball Mount and the trailer
tongue will close up.
www.parkit360.ca
To Next Page
Loading...
