PARKIT360 Force - Hooking up to the trailer

Parkit360 Force Owner’s Manual 11
Hooking up to the trailer:
1. Insert the ball mount into the
receiver on the Parkit360 Force.
2. Install the Ball Hitch by threading
it into the Ball Mount. The
bottom shoulder of the Hitch Ball
must be slightly below the top
surface of the Ball Mount Collar,
as shown.
3. Apply a generous portion of all-
purpose grease along the top
surface of the Ball Mount Collar.
4. Please note that there are weld
spots on the ball mount. These
must be oriented properly before
hooking up the trailer.
www.parkit360.ca