Parkit360 Force Owner’s Manual 14
Hooking up the trailer: Alternate methods
Jack Post Option
1. Remove the Ball Mount from the Parkit360 Force receiver
2. Lower the trailer jack into the receiver
3. You’re ready to go!
Important:
With the jack, lower your trailer as close to the Parkit360 Force wheels as you
can without them rubbing on the trailer frame. Doing this will reduce strain on
the jack shaft.
Telescopic Frame Adapter
1. Remove the Ball Mount from the Parkit360 Force receiver
2. Lower the telescoping pipe into the receiver
3. Slide the locking pin onto place
4. You’re ready to go!
Important:
Trailers with an articulated hitch should use the telescopic hitch adapter. DO
NOT USE the ball and ball mount attachment. Doing so could cause damage
to the unit, the trailer, or cause serious injury, including death.
www.parkit360.ca
To Next Page
Loading...
