Parkit360 Force Owner’s Manual 15
EZ Connect Option
Please follow these steps to assemble and use the optional EZ Connect option:
1. The EZ Connect option will be
shipped with the EZ Connect frame,
wheels (with mounting hardware), and
ball.
2. Mount the EZ Connect frame
assembly into the Ball Mount Receiver
as shown.
3. Use the forward hole to mount the
ball. This is the most stable
configuration. However, the rear hole
may be used if the forward one is not
practical to use due to space
considerations.
4. Finally mount the wheels using the supplied hardware. The unit is now ready to
use.
5. WARNING: When using the EZ Connect option, please restrict operation to a
maximum 3% grade, and 800 lbs of tongue weight
www.parkit360.ca
To Next Page
Loading...
