25
GB MT
b) Never repair damaged batter-
ies.
ried out by the manufacturer or author
ised customer service centres only.
Safety information for
drilling machines
1) Safety instructions for all work
a) Hold the appliance by the insu-
lated gripping surfaces when
performing work in which the
tool may come into contact with
hidden wiring. Contact with a live
wire can also cause a charge in metal
electric shock.
b) Do not use any accessories
that are not recommended by
(Parkside). This can result in electric
2) Safety information for using
long drills
a) Do not work at a speed higher
than the maximum permissible
speed for the drill.
can cause the drill to bend slightly
when rotating freely without contact
b) Always begin drilling at a low
speed and when the drill is in
contact with the workpiece.
bend slightly when rotating freely with
c) Do not apply excessive pressure
to the drill. Only apply pressure
lengthwise along the drill. Drills
can bend and break or cause a loss in
3) Residual risks
this electric tool, some residual risks will
remain. Due to its construction and build,
hazards:
a) Cuts
tection.
c) Damage to your health caused by
swinging your hands and arms when
riods of time or if the unit is not held or
electric tool generates an electro
the manufacturer of their medical
chine.
Observe the safety informa-
tion and notes on charging
and proper use as shown in
the instruction manual for
your battery and charger
from the (Parkside)
A detailed description of the
charging process and further
information can be found in
the separate operating in-
structions.
To Next Page
Loading...
