27
GB MT
2. Select:
Clockwise rotation: to drill
and screw in screws:
Press the direction switch (4), with
handle.
Anticlockwise rotation:
to unscrew screws: :
Press the direction switch (4), with
the handle.
switch lock: Move the rotation
direction switch (4) into its middle
The direction changed may only be
Torque setting
desired torque:
Screws:
Drilling:
increase according to requirement.
Tool change
to be changed even when the motor is at a
standstill.
1. Rotate the keyless chuck (1) towards
(11) is large enough to accommodate
the tool.
keyless chuck (1).
3. Turn the keyless chuck towards
in
4. To remove the tool again, rotate the
Removing the keyless
chuck
To use the bit holder (18), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly from
ring (19) in the direction of the keyless
chuck (1).
2. This unlocks the keyless chuck (1) and it
ring (19) in the direction of the keyless
chuck. Push the keyless chuck (1) on as
far as it will go.
When attaching the keyless chuck,
a 25 mm bit may remain in the bit
holder (18).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (19).
Using the bit holder
After removing the keyless chuck (1) you
can use the bit holder (18).
holder (18).
To Next Page
Loading...
Need help?
General
