Parkside 292195 - User Manual

Other manuals for Parkside 292195

Operation And Safety Notes Translation Of Original Operation Manual44 pages

Questions and Answers

A
Andrea MartinezAug 11, 2025
What to do if my Parkside 292195 Air Compressor does not start?
- T
  Travis AndersonAug 11, 2025
  If your Parkside Air Compressor doesn't start, there are several potential causes. First, check the supply voltage, power plug, and socket-outlet to ensure they are working correctly. It's also possible the outside temperature is too low; this compressor should not be operated below +5° C. Finally, the motor may be overheated, so allow it to cool down and address any underlying causes of overheating.
S
Sarah GrossAug 16, 2025
Why my Parkside Air Compressor starts but the tools won't start?
- R
  Robin RamirezAug 16, 2025
  If your Parkside Air Compressor starts and shows pressure, but the tools aren't working, it could be due to a few reasons. Check the compressed air hose and tools for leaks, replacing them if necessary. Also, inspect the quick-lock coupling for leaks and replace if needed. Finally, make sure the pressure regulator is set to a sufficient pressure; increase it if necessary.
R
Richard HernandezAug 20, 2025
How to fix a Parkside 292195 that starts but doesn't build pressure?
- R
  robert06Aug 20, 2025
  If your Parkside Air Compressor starts but isn't building pressure, the non-return valve may be leaking and should be replaced by a service center. Damaged seals could also be the culprit; have them checked and replaced by a service center if needed. Additionally, ensure the drain plug for condensation water is tightened by hand and that its seal is intact; replace the seal if necessary.
K
Keith SandovalAug 26, 2025
Why won't my Parkside Compressor start?
- C
  Carrie SmithAug 26, 2025
  If your Parkside Compressor isn't starting, first ensure there's proper supply voltage by checking the power plug and socket. Also, verify that the outside temperature is above +5° C. If the motor is overheated, allow it to cool down, addressing any potential causes of overheating.
J
Joshua BryantAug 30, 2025
What to do if my Parkside Compressor tools do not start?
- M
  Michelle OrrAug 30, 2025
  If your Parkside Compressor shows pressure but your tools aren't starting, check the compressed air hose and quick-lock coupling for leaks and replace if necessary. Also, make sure the pressure regulator is set to a sufficient pressure; increase it if needed.
J
jasmine71Sep 5, 2025
How to fix a Parkside Compressor that starts but has no pressure?
- C
  Christina ValentineSep 5, 2025
  If your Parkside Compressor starts but isn't building pressure, the non-return valve may be leaking and require replacement by a service center. Damaged seals could also be the cause; have them checked and replaced if needed. Ensure the drain plug for condensation water is tightened by hand and inspect/replace its seal if it's leaking.