EasyManua.ls Logo

Parkside PASD 4 B2 - Charging the Battery; Checking the Bits; Checking the Charge Status of the Battery; Initial Start-Up

Parkside PASD 4 B2
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
GB
or order number 80001039
(JLH100501700B1 for UK.
-

,


 
latest safety instructions, as
well as the regulations and
information relating to envi-

Defects resulting from im-

covered by the warranty.
Charging the battery

the charging cable into the

2. Connect the charging cable
connector (11) with the
charging socket (7) on the
device.

into a socket.
4. The battery indicator (8)

red = 0 - 50 % charged
yellow = 51 - 99 % charged
green = 100 % charged

-

6. Remove the charging cable
connector (11) from the
charging socket (7).
Initial start-up
Checking the charge
status of the battery
battery

green: 50 - 100 %
yellow: 49 - 30 %
red: < 30 %
Checking the bits
Only the insulated bits from

suitable for working under
voltage 1000 V.
Before each use, the insu-

by the user. Check the
insulation for any damage,
among other things.
If there is any doubt about
the safety of the insulated

Table of Contents

Related product manuals