GB IE NI
35
Maintenance intervals
Regularly carry out the maintenance work listed in the “maintenance intervals” table.
Regular maintenance prolongs the life of the equipment. It also gives optimum cutting
performance and avoids accidents.
Maintenance Work
(See “cleaning and
maintenance“)
Before After After
1st
5 Hrs.
After
8 Hrs.
After
50
Hrs.
Annual
Work
Check and tighten screws, nuts
and bolts
√
Check the engine oil level/
petrol level and refill with
engine oil/petrol if required
√ √
Clean operating elements / the
area around the silencer
√ √
Clean the finger protection
b
√
Change the engine oil
√ √ √
Replace the air filter
a
√
Clean/adjust the spark plug
Replace the spark plug
√ √
Check the silencer and spark
catcher
b
√ √
Clean the air cooling system
a,b
√
Charge the electric starter
battery
√
a
Replace more often if there is a high level of dust or heavy dirt
b
See Briggs & Stratton instruction manual
Please note the listed spare parts: front wheel (KCL16B-12), blade (KCL19-6A), return
spring (KCL19-19), Height adjustment handle (KCL19-18A), rear wheel (KCL19-11A)
Quick release (KCL16B-17), cable (KCL19-56S).
To Next Page
Loading...
