Parkside PDOS 200 C2 - User Manual

Questions and Answers

K
Kelly SanchezAug 12, 2025
What to do if my Parkside PDOS 200 C2 doesn't start?
- K
  Kathryn JohnsonAug 12, 2025
  If your Parkside Grinder doesn't start, there could be several reasons: * The mains voltage might be missing, or the main circuit breaker could be tripped. Check the socket, mains cable, line, and mains plug. If necessary, have repairs carried out by a qualified electrician. Also, check the main circuit breaker. * The on/off switch may be defective. In this case, get it repaired by Customer Care. * The engine might be faulty.
T
Thomas WeaverAug 20, 2025
Why is my Parkside Grinder engine slower and then stops?
- A
  Alicia BlackwellAug 20, 2025
  If the Parkside Grinder's engine slows down and stops, it could be due to: * Overload caused by the workpiece. Reduce the pressure on the grinding tool. * The workpiece being unsuitable.
B
Beth TrevinoAug 27, 2025
What to do if grinding disc does not rotate smoothly and abnormal noises can be heard in Parkside PDOS 200 C2 Grinder?
- K
  Kimberly HendersonAug 27, 2025
  If the grinding disc doesn't rotate smoothly and you hear abnormal noises, it could be due to: * A loose grinding disc nut. Tighten the grinding disc nut. * A faulty grinding disc. Change the grinding disc. * Incorrectly set spark protection or workpiece support. Adjust the spark protection or workpiece support.
D
dustinbergSep 3, 2025
What to do if grinding tools do not move although the engine is running in Parkside PDOS 200 C2?
- C
  crystal72Sep 3, 2025
  If the grinding tools don't move even though the engine is running, it could be due to: * A loose grinding disc nut. Tighten the grinding disc nut. * A blockage in the drive caused by the workpiece, remaining workpieces, or remaining grinding tools. Remove any blockages.

Parkside PDOS 200 C2 Specifications

General

Power	200 W
Rated Input	200 W
Protection Class	II
Cable Length	2 m
Rated Voltage	230 V
Disc Diameter	150 mm
Belt Speed	900 m/min
Grinding Wheel Size	150 x 20 x 12.7 mm