Parkside PHD 100 A1 - Trouble shooting; Washer Not Operating; No Pressure Generation; Pressure Fluctuations

14
GB IE
Trouble shooting
Problem Possible cause Remedy
Washer is
not opera-
ting
ON / OFF switch (5) is turned
off
Check ON / OFF switch
Damaged power supply cable
Check power supply cable (7) for
damage. If necessary have the power
supply cable (7) replaced by a qualied
electrician.
Mains fault
Check the electrical system for confor-
mity with the data on the rating plate.
Washer
does not ge-
nerate any
pressure
Air trapped in the pressure
washer
Turn on the washer with high-pressure
hose until bubble-free water ows out
of the high-pressure connection (3).
Drop in the water mains
pressure
Check the water mains.
Severe
pressure
uctuations
High-pressure nozzle (13) is
dirty
Rinse the high-pressure nozzle (13)
with water. If necessary clean the noz-
zle hole with a needle.
Spare Parts Order
When buying parts for the pressure washer, use the service address or fax number
given.
Please enter your machine type and the product number of the part you are ordering.
A
Item Description ........................................................................... Product No.
14 Cleaning agent container with nozzle ........................................ 91096764
13 High-pressure nozzle ................................................................. 91096765
1-2 High-pressure hose .................................................................... 91096766
12 Adjustable at-jet nozzle............................................................. 91096767
11 Jet lance .................................................................................... 91096768
10 Gun ............................................................................................ 91096769