Why won't my Parkside PLS 2600 A1 start?
Your Parkside Blower might not start due to several reasons: * There is no mains power supply. Check the socket, cable, line, plug and fuse, and if needed, have them repaired by a qualified electrician. * The carbon brushes are worn out. In this case, it should be sent to a Service Centre for repair. * The motor is faulty. * The On/Off switch is defective.
What to do if the impeller does not move in my Parkside Blower?
If the impeller in your Parkside Blower doesn't move, it might be due to a foreign body blocking it. In this case, you should remove the blockage (refer to the section on "Removal of clogging and blockage").
What to do if my Parkside Blower has weak suction power?
If your Parkside Blower has weak suction power, it could be due to: 1. A full collection bag. Empty the collection bag. 2. A dirty collection bag. Clean the collection bag. 3. A clogged or blocked impeller, blower, or suction pipe. Refer to the section on "Removal of clogging and blockage".
Why does my Parkside PLS 2600 A1 have intermittent operation?
If your Parkside Blower operates intermittently, the cause may be: * An internal loose contact. It should be sent to a Service Centre for repair. * A damaged power cable. * A defective On/Off switch.
To Next Page
General
