EasyManuals Logo

Parkside PLS 48 D2 Instructions For Use

Parkside PLS 48 D2
Go to English
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
28 PLS 48 D2
| GB | IE
Soldering
Inhaling the vapours may lead to headaches and fatigue
symptoms.
The soldering iron with a rated power of 48 watts is ideal for electronic
soldering.
Due to its design, it is particularly suitable for difficult to access and fine
soldering work.
Clean the soldering tip
t on a moist solder sponge
s
.
After cleaning, the soldering tip must be tinned. Tin the hot soldering tip
by melting the solder o.
Bring the soldering tip to the soldering point and heat it.
Bring the solder (with flux) between the soldering point and the soldering
tip.
Apply additional solder until the entire solder joint is covered.
Immediately remove the soldering tip to avoid overheating the molten
solder.
Let the solder solidify and avoid vibrations.
NOTE
f The flux is either contained in the solder or it is applied separately.
When purchasing, please find out about the type of application
and the appropriate solder

Table of Contents

Other manuals for Parkside PLS 48 D2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside PLS 48 D2 and is the answer not in the manual?

Parkside PLS 48 D2 Specifications

General IconGeneral
BrandParkside
ModelPLS 48 D2
CategorySoldering Gun
LanguageEnglish

Related product manuals