Parkside PLS 48 D2 Instructions For Use

31 PLS 48 D2
GB | IE |
Warranty coverage
The device was produced carefully according to strict quality guidelines and
tested diligently prior to delivery.
The warranty applies to material or factory defects. Excluded from the
warranty are wear parts subject to normal wear and damages to fragile
parts e.g. switches, batteries or other parts manufactured from glass.
This warranty expires if the product is damaged, not used as intended or
not serviced. For the proper use of the product, all instructions listed in the
operating instructions must be observed carefully. Any form of use and
handling that is advised against in the operating instructions or warned
against must always be avoided.
The product is only intended for private and not for commercial use. In the
case of incorrect and improper handling, use of force and interventions not
performed by our authorised Service Centre, the warranty shall cease.
Handling in case of a warranty claim
In order to ensure prompt handling of your case, please observe the
following notes:
 Please keep the article number (e.g. IAN 12345) and the purchase
receipt as a verification of purchase for all inquiries.
 The article number can be found on the rating plate, an engraving, the
title page of your instructions (at the bottom left) or as a sticker on the
back or the underside of the device.
 If faulty operation or other defects occur, first contact the service centre
listed in the following by telephone or email.
 Then you will be able to send a product reported as defective free of
charge to the service address specified to you, including the purchase
receipt and the information on the defect and when it occurred.

Parkside PLS 48 D2 Specifications

General

Brand	Parkside
Model	PLS 48 D2
Category	Soldering Gun
Language	English