To Next PageTo Next PageWhat to do if the welding helmet slips when using Parkside PSH 3 A1 Motorcycle Accessories?
If the welding helmet slips when using Parkside Motorcycle Accessories, it might be because the headband has been put on incorrectly. Try putting the headband on again, ensuring it is tighter.
Why is the visibility poor when using Parkside Motorcycle Accessories?
If the visibility is poor when using Parkside Motorcycle Accessories, several factors could be responsible. First, check if the protector or the protective screen is dirty and clean it. Ensure that you have removed the protective film from the protective screen. Insufficient ambient light could also be the cause, so increase the light in your work area. Finally, verify that the correct darkening shade is set and reset it if necessary.
What to do if the filter does not darken in a normal way or flickers on Parkside Motorcycle Accessories?
If the filter on your Parkside Motorcycle Accessories isn't darkening properly or is flickering, start by cleaning or replacing the protector. Also, ensure that the arc sensor is clean. If the welding current is too low, try setting the sensitivity to the maximum level.
Why is the reaction slow when using Parkside Motorcycle Accessories?
If the reaction time is slow with your Parkside Motorcycle Accessories, it might be due to the ambient temperature being too low or too high. Ensure you are using the welding helmet in temperatures between -5 °C and +55 °C. Also, the sensitivity might be set too low; try increasing it.
General| Brand | Parkside |
|---|---|
| Model | PSH 3 A1 |
| Category | Motorcycle Accessories |
| Language | English |
