21GB/IE/NI
Operation
Inserting/replacing the
battery
Open the battery compartment cover [] with
a Phillips screwdriver.
If necessary, remove the used battery.
Insert a new 3 V button cell (type CR2032)
in accordance with the polarity shown. Screw
the lid of the battery compartment cover
[]
back on.
m
CAUTION!
u If operating and adjustment equipment
is used or procedures other than those
specified here are carried out, this may
result in hazardous radiation exposure.
NOTE
u The product is equipped with a power on/
control lamp
[5], which lights up green as
soon as the product is connected to the
mains. This action indicates that the product
is live.
Check base plate/blade guard
m
WARNING! RISK OF INJURY!
Always remove the power plug from
the mains power socket before carrying
out any work on the product.
Check the freedom of movement of the base
plate
[7] before each use.
Activate the safety lock-out
[2] and keep it in
that position. Lower the circular saw. In this
way, you can test the function of the base
plate
[7]. The base plate must move freely
and may not jam.
After letting go, it must be move smoothly
back to its starting position of its own accord.
To Next Page
Loading...
