11
NIIEGB
Only use the original charger from
the package to charge the battery.
• The device may only be powered
with SELV (Safety Extra Low Vol-
tage) as marked on the device.
• Charge the battery before the rst
time of use.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.
Recharging the battery
1. Connect the charger plug to the
charging socket ( 6) of the de-
vice.
2. Plug the battery charger ( 11)
into a mains outlet.
3. When the battery is fully re-
charged unplug the battery
charger (
11) from the mains.
Red LED lights up
Battery charging
Green LEDs light up Battery fully
charged
Checking the battery charge
level
The battery’s charge level is indicated by
the charge state indicator (
5).
The state of charge of the battery is displa-
yed by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch (
9) must be pressed.
Green LED lights up
Battery fully charged
Red LED lights up
Battery needs to be charged
Starting up
Before the starting up must
the transport safety ( 1)
removed.
Open the transport safety (
1) and remo-
ve the transport safety of the bit holder
(
3).
Operation
1. Direction switch
You can toggle between right and left ro-
tation by pushing the direction of rotation
switch (
8).
If you move the direction switch (
8) to
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
2. Bit selection from the
bit changeable drum
Push the slide of the interchangeable cord-
less screwdriver (
4) forward.
Turn the bit changeable drum to the left or
right until the desired bit is located on top
and is in line with the bit holder (
3). The
bit changeable drum engages audibly.
Push the slide of the interchangeable cord-
less screwdriver (
4) to the back.
To Next Page
Loading...
Need help?
General
