STARTING
Adjusting Guard
.- ,,j
:
.
;
1.
A
WARNING: Disconnect tool from power supply and be sure switch is in off position
before adjusting guard. The guard should always be adjusted so that the rear section is in
contact with the work piece so that ground off particles and sparks are trapped by the
guard, and directed away from the operator
CHECKINGGUARDPOSITION
2.
A
WARNING: Grasp tool firmly with both hands, and with fingers encircling the handles,
before attempting to start.
3. Grasp switch ban-dFe firmly and squeeze to depress trigger. To stop tool, release trigger.
STARTING POSITION
6
To Next Page
Loading...
