English – 5
SAFETY INSTRUCTIONS
3 Muffler
!
WARNING! The muffler gets very hot during
use and remains so for a short time
afterwards. Do not touch a hot muffler!
The muffler is designed to
give the lowest possible noise
level and to direct the engine‘s
exhaust fumes away from the
user. The engine‘s exhaust
fumes are hot and can contain
sparks, which can lead to the
outbreak of fire.
Never use a power cutter that
has a faulty muffler.
Check regularly that the
muffler is secured to the
engine body.
IMPORTANT INFORMATION! It is extremely important
that the instructions for checking, maintaining and
servicing the muffler are followed. (see the section on
Inspecting, maintaining and servicing power cutter’s
equipment).
4 Blade guard for the cutting blade
!
WARNING! Always check that the blade
guard is correctly fitted before starting the
machine.
This guard is fitted above the
cutting blade and is designed
to prevent parts of the blade
or cutting fragments from
being thrown towards the
user.
The blade guard is mounted
above the cutting blade and
prevents cutting fragments
from being thrown towards the
user.
!
!
WARNING! Check that the cutting blade is
fitted correctly and does not show signs of
damage. A damaged cutting blade can cause
personal injury.
WARNING! Never use a power cutter with
defective safety components. The power
cutter’s safety equipment must be checked
and maintained as described in this
Operator’s Manual. If your power cutter fails
any of these checks contact your service
workshop to get it repaired.
2 Stop switch
The stop switch should be
used to stop the engine.
Start the engine and make
sure that the engine stops
when the stop switch is
moved to the stop position.
GENERAL SAFETY INSTRUCTIONS
IMPORTANT INFORMATION! A power cutter is designed
to cut hard materials such as concrete/stone and steel/
iron. Observe the increased risk of kickback when cutting
soft materials.
Do not use the power cutter until you have read the
entire contents of this Operator’s Manual.
All servicing, in addition to the points listed in the
section ”
Control, maintenance and service of the
power cutter’s safety equipment”
, should be carried
out by trained service specialists.
• Never use the machine when you are tired, under the
influence of medicines/drugs or alcohol.
• Never start a power cutter indoors. Be aware of the dangers
of inhaling the engine’s exhaust fumes.
• Do not lend out the power cutter without including this
Operator’s Manual. Ensure that the person who intends to
use the power cutter understands the information in the
Operator’s Manual.
Transport and storage
• Store the power cutter in a lockable area so that it is out of
reach of children and unauthorised persons.
• Do not store or transport the power cutter with the cutting
blade fitted.
To Next Page
Loading...