Need help?Do you have a question about the Partner K750 and is the answer not in the manual?
Read manual, check blades, verify idling settings, and seek dealer inspection.
Mandatory PPE for safe operation including helmet, hearing protection, goggles, mask, gloves, clothing, and boots.
Details purpose and checks for safety equipment such as vibration damping system, stop switch, and muffler.
Procedures for checking and maintaining safety features like throttle lock, stop switch, and blade guard.
Covers safe operation, avoiding kickback, fuel handling, transport, and storage precautions.
Guidelines for safe storage and transport of the power cutter and its cutting blades.
Precautions for handling fuel to prevent fire, explosion, and inhalation of fumes.
Basic safety rules for operating the power cutter, emphasizing awareness and stable working position.
Safety advice specific to the cutting process, including maintaining safe distance and proper technique.
Explains kickback phenomena and provides rules to prevent it, focusing on proper working technique.
Instructions on how to sharpen diamond blades to maintain their cutting performance.
Explains causes of blade vibration and provides methods for prevention.
General information about abrasive discs and diamond blades, including their types and uses.
Safety and usage guidelines for performing wet cutting with diamond blades.
Instructions for dry cutting with diamond blades to prevent damage from overheating.
Details on diamond blade construction, types, hardness classes, and material suitability.
Inspect drive axle and flange washers for damage and correct dimensions before assembly.
Procedure for correctly fitting cutting blades, including use of bushings and correct tightening torque.
Instructions for fitting and adjusting the blade guard to ensure operator safety.
Precautions and essential steps for safe refuelling of the machine.
Procedure for starting the engine when it is already warm.
Step-by-step guide for starting the engine from cold, including choke and throttle lock use.
Method for stopping the engine using the main stop switch.
Procedure for adjusting the tension of the drive belt.
Steps for safely removing and fitting a new drive belt.
Important warning: Do not start engine with belt pulley/clutch removed.
Information on carburetor settings and troubleshooting for poor engine performance.
Guide on how to correctly adjust the engine's idle speed.
Location, replacement, and maintenance requirements for the fuel filter.
Instructions for cleaning and replacing foam and paper air filters.
Warnings and procedures for changing starter cord and recoil spring.
Detailed steps for replacing a broken or worn starter cord.
Procedure for tensioning the starter recoil spring.
Steps for replacing a broken recoil spring assembly.
Factors affecting spark plug condition and how to clean and check it.
Importance of cleaning the cooling system for optimal engine health.
Function of the muffler and warnings regarding its heat and potential sparks.
Routine checks for throttle, belt, blade, guard, starter, nuts, screws, and stop switch.
Checks for air filter, handles, spark plug, flywheel fins, cooling fins, muffler, and idling settings.
Checks for paper filter, clutch, carburetor, fuel filter, and fuel cap.
Specifications for cutting blades, including peripheral speed and output shaft speed.
Manufacturer's declaration of compliance with EU directives and applied standards.
To Next Page
General
