Partner K750 - Contents; Table of Contents

English
– 3
CONTENTS
Contents
KEY TO SYMBOLS
Key to symbols ............................................................. 2
CONTENTS
Contents ...................................................................... 3
WHAT IS WHAT?
What is what on the power cutter? ............................... 4
SAFETY INSTRUCTIONS
Steps before using a new power cutter. ....................... 5
Personal protective equipment ..................................... 5
Machine ′ s safety equipment ........................................ 6
Checking, maintaining and servicing the machine ′ s
safety equipment .......................................................... 7
General safety precautions .......................................... 8
General working instructions ....................................... 9
Cutting blades .............................................................. 11
ASSEMBLY
Checking the drive axle and flange washers ............... 13
Fitting the cutting blade ................................................ 13
Guard for the blade ...................................................... 13
FUEL HANDLING
Fuel .............................................................................. 14
Fuelling ........................................................................ 14
STARTING AND STOPPING
Starting and stopping ................................................... 15
MAINTENANCE
Tensioning the drive belt .............................................. 16
Replacing the drive belt ............................................... 16
Belt pulley and clutch ................................................... 16
Carburettor ................................................................... 16
Fuel filter ...................................................................... 17
Air filter ......................................................................... 17
Starter .......................................................................... 18
Spark plug .................................................................... 19
Cooling system ............................................................ 19
Muffler .......................................................................... 19
General maintenance instructions ............................... 20
TECHNICAL DATA
Cutting equipment ........................................................ 21
EC-declaration of conformity ........................................ 22