SETTING UP THE TENT
1. Open the roof of the star tent. Tip: Before you begin, lay down a groundsheet to prevent
the tent from getting dirty whilst you are setting it up.
2. Take the protective pocket from around the horseshoe-shaped end of each leg (a) and
slide the horseshoe-shaped end of each leg over the corresponding peg (b).
3. Mount the pole of the star tent by sliding the poles into each other in the correct sequence.
PLEASE NOTE! This manual is based on a star tent of 8.65 by 13.65 m. For this star tent you
do not need one of the two identical tubes for the pole (tube 3 or 4). For all other sizes, you
need all of the tubes to assemble the pole.
1.
2b.
2a.
3.
1 2 3 4 5
30 VEGA MANUAL
EN
To Next Page
Loading...