2. Warranty and safety instructions
CAUTION
In the appliance connected to the energizer circulating potentially
lethal voltages and currents, you are requested, for your safety, to
observe the electrical safety standards, make all connections always
with the energizer turned off, never leave the instrument unattended
and keep away inexperienced staff, children and animals.
This equipment allows you to perform measurements of electrical resistivity of the
ground, measures of induced polarization (IP) and measures of spontaneous potential
(SP). Using the instrument for other uses for which it was not designed may void the
warranty and generate hazardous situations.
In order to use the equipment properly and correctly, it is necessary to have geological
and geophysical skills. On request we can provide a bibliography containing the titles of
some texts to be consulted, if necessary.
Read the instructions carefully before using the product:
- This device has been designed and built to make electrical ground resistivity
measurements possible for geophysical / geological purposes. A careful reading of this
manual is recommended before proceeding with use.
- Warranty will be void if the product is used in any ways that is in contradiction with
the instructions given in this manual.
- Warranty will be void if the instrument has been tampered with.
- The device must only be used only according to the instructions described in this
manual. Faultless and safe operation of the device can be guaranteed only if the
transport, storage, handling and operation of the device is appropriate.
- To avoid damage, use only original accessories or approved by PASI srl.
- The box is waterproof only if closed. When a suitable location has been selected for
the device, it must be ensured that no water can get into the device under any
conditions. Direct sunlight is also to be avoided for long periods. It is not recommended
that the instrument is installed on a strongly vibrating surface.
To Next Page
Loading...
Need help?
General
