INTRODUCTION OF CLEANING AND INSTALLATION OF THE MACHINE：
01
02
03
04
05
06
Add disinfectant powder to
9.5L normal temperature
water and mix them.
After cleaning,install clip
scraper and beater shaft
Install beater and
adjust the shaft
Cleaning spare
parts with 5L
disinfectant water.
Smear lubricant on O-ring
and install O-ring to piston.
Smear lubricant on
Discharge door and
install discharge
door O-ring
PASMO
PART
06
PASMO
PASMO OPERATION MANUAL
ＰＡＳＭＯ ＯＰＥＲＡＴＩＯＮ
09
PLEASE OPERATE THE MACHINE CORRECTLY
To Next Page
Loading...
