PASMO
PART
07
PASMO
PASMO OPERATION MANUAL
ＰＡＳＭＯ ＯＰＥＲＡＴＩＯＮ
11
PASMO
AIRPUMP INSTALLATION：
PLEASE OPERATE THE MACHINE CORRECTLY
① Access of motor of air pump -
you can take out from machines. The air pump will not work if
incorrectly installed.
② Air pump, and behind the air pump must install seal and lubricate.
③ The O-ring for the air pump, needs to be lubricated before install to ensure a
tight seal.
④ Air pump gear - the two sides of the gear need to be lubricated (Note: Please wash
gears with cold water).
⑤ Air pump faceplate, it is better to lubricant this part as well.
⑥ Adjust duct of air pump - first install all parts according below image (plug,spring,
O-ring),it needs to be adjusted to the maximum hole during mix feed. To do this facing
machine, set to the maximum hole by moving the adjustable lever all the way to the left. To
adjust to the minimum hole, adjust duct to right, the overrun will be higher. You need to
adjust the hole according to the thickness of your soft Serve Mix and the customers flow
volume. The thicker the mix is, the more customers drawing product, the larger the hole will
need to be (duct on left).
⑦Air pump tube.
(note: all parts should be cleaned every day to avoid growth of bacteria)
To Next Page
Loading...
