~
ItJ .
SERVICE electra 3000 A I
ANLEITUNG INSTRUCTION INSTRUCTION INSTRUCCION
20. -Place cam box back (with driver for 9am box) on the machine and
connect to the electra by pressing the slider (1) into the clutch
on the toothed belt as shown in the sketch below.
Place cam box front on the machine and connect to cam box back.
=~~~ @ cg
-0- ~ 1 I
(
~
~ 21. -Plug foot controller cable into socket on electra.
-Plug mains plug into wall socket. i
~
-The electra is now ready for use by following the enclosed
operating instructions.
-Before actually knitting with the electra, become fully
acquainted with it by operating it without wool and following
the instructions very carefully.
22. On the next pages fitting of the following accessories to the electra
is shown:
-FORMA
-Lamp
-MFS-80 and MFS-72 (Multiple yarn guide)
~ -Fitting of the FORM COMPUTERS to the electra is shown in the instruction
~ book art.no. 33.205.73 for FORM COMPUTER. Fitting to the electra 3000A
~ is the same as to the electra 2000 and 3000.
To Next Page
Loading...