EE
AA
Mounting Screw
x 2
Wire Connector
x 3
CC
BB
Mounting Bracket with
Screws (pre-attached)
x 1
WARNING
HARDWARE CONTENTS Note: Hardware not shown actual size.
PACKAGE CONTENTS
SAFETY INFORMATION
CARE AND MAINTENANCE
TROUBLESHOOTING
1. The light does not come on at all.
a) Make sure the wall switch and circuit breaker are on. b) Make sure the wiring is correct.
2. Fuse blows or circuit trips when light is turned on.
a) Check for crossed wires, ensure wiring is correct.
If unable to fix any of the above issues, please consult a certified electrician.
Rubber Washer x 2
(pre-attached)
DD
Fixture Screw x2
(pre-attached)
ASSEMBLY INSTRUCTIONS (continued)
Step 8. After installation, seal around the top
and side perimeter between the fixture
and the wall surface with weather
resistant caulking (not included).
FIVE-YEAR LIMITED WARRANTY: If, during normal use, this PATRIOT LIGHTING lighting fixture breaks or fails due
to a defect in material and workmanship within five years from the date of original purchase, simply bring this lighting
fixture with the original sales receipt back to your nearest MENARDS store. At its discretion, PATRIOT LIGHTING
agrees to have the product or any defective part(s) repaired or replaced with the same or similar PATRIOT LIGHTING
product or part free of charge, within the stated warranty period, when returned by the original purchaser with original
sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs; (2) does not cover
damage that has resulted from abuse or misuse; and (3) does not cover any losses, labor, injuries to persons/property
or costs. This warranty does give you specific legal rights and you may have other rights, which vary from state to state.
R
RR
R
To clean, turn off and wipe with a damp and soft cloth; Do not use detergent or abrasives for cleaning.
Please read and understand this entire manual before attempting to assemble, operate or install the product.
Before beginning the installation or operation of product, make sure all parts are present. If any part is missing or
damaged, do not attempt to install or operate the product. Contact customer service for replacement parts.
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching
off circuit breaker).
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or
death from electric shock.
This product must be installed in accordance with the applicable installation code by a person familier with construction
and operation of the product and hazards involved
SKU Number: 356-9484 356-9485
Model Number: WL024 WL023
Dual Head Security Light
FF
Coverplate gasket
x 1 (pre-attached)
Step 7. Install the light bulb (B)
(not included).
To Next Page
Need help?
General
