8
Error prompt and code running status
1. "E1" code: This code appears when the copper head sensor is damaged.
The machine will keep running, but every 30 minutes , the compressor will
stop for about 10 minutes, then continue to run . After that ,the machine
will repeat the cycle like this.
2. "E2" code: This code appears when the temperature and humidity sensor
is damaged. The machine will keep running, but every 30 minutes , the
compressor will stop for about 10 minutes, then continue to run . After
that ,the machine will repeat the cycle like this.
3. "E4" code: This code appears when water tank of water pump is full or
failure of water pump, the machine will stop running.
Cautions:
If unit malfunctions turn off the unit and unplug it immediately. Please
contact your distributor for service issues.
Do not dispose of electrical appliances in local landfills, or
municipal waste locations. Many parts are recyclable.
Contact your local government for information regarding the
collection systems available in your area.
To Previous Page
Loading...