Toll Free 1-800-443-5542 HERE TO HELP
[
17
]
When using softboxes by other manufacturers,
you will need to get a Paul C. Buff™ compat-
ible speedring. When mounting accessories to
the faceplate, ensure that all four holding ngers
are within the opening and that the quick-release
levers have returned rmly to the open position.
Failure to do so can result in the unintended
release of the modier from the light.
Note:
The Einstein™ unit mounts all accessories
that t previous Paul C. Buff™ lights except the
obsolete WL130, WL5,000 and WL10,000 models.
The PLM™ System and Umbrellas: The Einstein™
unit has an umbrella shaft that runs along the top
length of the unit housing, tting standard umbrella
poles up to 23/64” (approx. 9mm) in diameter. It
may be used with the PLM™ system (both current
and previous models) as well as retired Paul C.
Buff™ umbrellas. The PLM™ system’s on-axis
speedring mount may be used as well.
Light Stands: The Einstein™ unit must be securely
mounted to a light stand for use. The stand mount
is compatible with most standard light stands
having top couplers up to 5/8-inch and may be
used on our full line of Paul C. Buff™ light stands.
Travel Gear: One Einstein™ unit can be carried in
our PCBBAG Paul C. Buff™ single-light carrying
bag (with the shipping cover, either the 7” or 8”
reector, cords and room for other small acces-
sories).
Note:
The PCBAG is for around-town travel
only; it is not suitable for airline travel. For consid-
eration of travel cases from other manufacturers,
the unit’s dimensions are 7” height x 5.4” width x
7.8” length (with lamps, dome and shipping cover
in place; mounting hardware attached).
If you need help or have questions about using
a particular accessory with your Einstein™ ash
unit, contact our Customer Service team for
assistance.
Paul C. Buff™ CSXCV Transceiver
PocketWizard® PowerMC2
Paul C. Buff™ Einstein™ faceplate
umbrella mount
light stand mount
Paul C. Buff™ PCBBAG carrying bag
To Next Page
Loading...