Paul C. Buff Einstein E640 - CyberSync System Integration; New Setups with Cyber Commander; Remote Control Parameter Transfer

[
18
]
EINSTEIN
™
by Paul C. Buff
USING EINSTEIN
™
WITH THE CYBERSYNC
™
SYSTEM
For complete wireless ring and full parameter adjustment, the Einstein™ unit can be used with
the CyberSync™ CSXCV Transceiver and the Cyber Commander™ remote control. With this
setup, the Cyber Commander™ unit can also be used to remotely power on an Einstein™ unit
that is plugged into a power source. For complete information about the optional CyberSync™
system, visit our website (www.paulcbuff.com/cybersync.php).
Setting up the Einstein™ unit with the Cyber Commander™ remote: Unlike setting up vintage Buff™
lights in the Cyber Commander™ remote, it is not necessary to perform the tedious “Spec
Lights” and “Light Settings” steps required by lights that communicate via CSR+ or CSRB+
receivers. The Einstein
TM
/ CSXCV combination allows all of the Einstein
TM
unit’s back panel
settings to automatically be transferred to the Cyber Commander
TM
remote. Acquiring this
information and recognizing Einstein
TM
units is accomplished by using one of the methods
detailed below.
Note: Below, there are two instruction sets for setting up Einstein
TM
ash units
with the Cyber Commander™ remote. The rst set (NEW SETUPS) starts the setup process from
scratch, erasing any programming already made in the Cyber Commander™ remote. Any
information erased will have to be reprogrammed, including light specications and names. To
keep existing light information programmed in your Cyber Commander
TM
remote, please follow
only the steps in the second section (EXISTING SETUPS).
Einstein™ and CyberSync™ NEW SETUPS: Use these instructions to set up the Einstein™ unit as
part of a new setup with no existing lights - this will erase any information already programmed
in the Cyber Commander™ remote!
1. Using the FUNCTION and ADJUST buttons on the Einstein
TM
unit’s back panel, ensure that the
unit is set to a unique channel not shared by any other light / CyberSync
TM
receiver, and set
to the same frequency as your Cyber Commander
TM
remote.
2. Enter the Cyber Commander
TM
remote’s setup menu by scrolling to the right with the right
joystick. In the setup menu, use the right joystick to highlight and select OPEN MEMORY.
3. Using the left joystick, select STUDIO in the lower left corner. Your screen should now read
OPEN ALL FROM STUDIO, followed by SYNC CYBER COMMANDER FROM STUDIO LIGHTS.
4. Press in on the right joystick. SYNC CYBER COMMANDER FINISHED OPENING should appear.
5. The Einstein
TM
unit is now dened as Einstein 640 and the remote is set with all parameters
for the unit as they appear on its back panel. No further action is required. Any parameter
changes should now be made with the Cyber Commander™ remote as any changes made
on the back panel will be overridden by the settings in the Cyber Commander™ remote.
Note: All non-digital Paul C. Buff™ ash units (White Lightning
TM
, AlienBees
TM
, and Zeus™
units) will require the specication process as outlined in the Cyber Commander
TM
manual.